Replacing The Fuse - Weston PRO-1100 Mode D'emploi

REPLACING THE FUSE

If the Vacuum Sealer does not operate when it is plugged
in and turned on, try any or all of the following:
1. Make sure the Fuse is not blown. The Fuse is located
on the right side of the unit directly above the Power
Cord Port. Turn "OFF" and unplug the Vacuum Sealer.
Twist off and remove the Fuse Holder. Remove and
check the Fuse. The thin metal band in the center of the
Fuse should be clean and unbroken. If it is burned and/or
broken, replace it with a new Fuse (8 Amp). Replace the
Fuse Holder.
2. Make sure the Connector at the end of the Power Cord
is plugged completely into the Power Cord Port.
3. Make sure the Power Cord is not damaged. DO
NOT use a damaged Power Cord. Call the Customer
Service line for information on part replacement.
4. Try connecting the Power Cord Plug to another
electrical outlet.
WARNING!
Before cleaning, assembling or disassembling the Vacuum Sealer,
make sure the Vacuum Sealer is OFF and the PLUG IS REMOVED FROM THE
OUTLET/POWER SOURCE!
FIGURE 13
17