Master Forge FL-6107-2SQ Mode D'emploi page 5

3. For some grills, the holes for attaching the rotisserie
are vertically lined up. If you are using this type of
grill, step 1 and 2 are not applicable. Follow this
step to reassemble the motor mounting bracket.
a) Find the motor mounting bracket (X-Y-Z). Loosen
the three screws that hold together Part X and
Part Y. Replace the Part X with Part W and tighten
the three screws. The new bracket consists of part Y
and Z and W.
b) Attach the newly assembled motor mounting
bracket (W-Y-Z) to grill.
NOTE: If the holes of your grills are horizontally lined
up, do not attempt to reassemble the motor bracket
to W-Y-Z motor bracket. The W-Y-Z motor bracket is
not applicable for any grills of horizontal holes.
Hardware Used
Alternate Bolt
DD
Alternate Nut
EE
Alternate Washer
FF
4. To accommodate several styles/designs of grills, the
motor bracket (X-Y-Z) is adjustable. Should the
motor bracket (X-Y-Z) as assembled not fit your grill,
please adjust the piece: Use a Phillips screwdriver
and pliers to loosen the screws on part Z of
motor bracket (X-Y-Z). Decide where you want to
mount the motor on the grill and move part Z to the
proper hole, tightening the screws securely.
5. If you are using Item #0135116, please follow the
steps below:
Attach the motor bracket (X-Y-Z) and
spit rod bracket (H) to your grill at an angle using the
proper holes of your grill.
Fig. 3
Y
Z
x 2
x 2
x 2
Fig. 4
Z
Fig. 5
H
5
Y
W
X
Y
X
hole
nut
Z
W
Y
Z
X
A
X-Y-Z