Extensions; Dry Applications; Maintenance And Repairs - Nilfisk VHW310 Manuel D'instructions

WARNING!
When the device is operating, do not:
■ Crush, pull, damage or tread on the cable that
connects to the electrical mains.
■ Only disconnect the cable from the electrical mains
by removing the plug (do not pull the cable).
■ Only replace the electric power cable with one of
the same type as the original: FROR, the same rule
applies if an extension is used.
■ The cable must be replaced by the manufacturer's
Service Centre staff or by equivalent qualified
personnel.
WARNING!
VHW310 vacuum cleaners are supplied without the
power supply cable, while VHW311 vacuum cleaners
are supplied with power supply cable with (VHW311T)
or without (VHW311) a 16 A plug, according to EC
regulations.
WARNING!
MODELS SUPPLIED WITHOUT POWER CABLE AND
CIRCUIT BREAKER PROTECTION
The user must provide a connection to the electrical
mains, according to the law in force, including a circuit
breaker protection appropriate to comply with the data
plate on the motor. This procedure must be performed
by qualified personnel.

Extensions

If an extension cable is used, make sure it is suitable for the
power input and protection degree of the vacuum cleaner.
Minimum section of extension cables:
Maximum length = 20 m
Cable = FROR
Max power (kW)
Minimum section (mm )
2
WARNING!
Sockets, plugs, cable clamps, connectors and
installation of the extension cable must maintain the IP
protection degree of the vacuum cleaner, as indicated
on the data plate.
WARNING!
The vacuum cleaner's power socket must be protected
by a differential circuit-breaker with surge current
limitation, that shuts off the power supply when the
current discharged to the ground exceeds 30 mA for
30 msec. or an equivalent protection circuit.
01/2015
Never spray water on the vacuum cleaner: this could
be dangerous for persons and could short circuit the
power supply.
Comply with the safety regulations governing the
materials for which the vacuum cleaner is used.

Dry applications

The supplied filters and the bag (if applicable) must be
installed correctly.
Comply with the safety regulations governing the
materials for which the vacuum cleaner is used.

Maintenance and repairs

Disconnect the vacuum cleaner from its power
source before cleaning, servicing, replacing parts or
converting it to obtain another version/variant, the
plug must be removed from the socket.
■ Carry out only the maintenance operations
■ Use only original spare parts.
■ Do not modify the vacuum cleaner in any way.
Failure to comply with these instructions could
jeopardize your safety. Moreover, such action would
immediately void the EC declaration of conformity/
incorporation issued with the device.
1.5
1.5
5
WARNING!
WARNING!
[ NOTE ]
WARNING!
WARNING!
described in this manual.
VHW310 - VHW311
GB
C391