Kohler K-98741 Guide D'installation Et D'entretien page 25

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Troubleshooting (cont.)
Troubleshooting Table
Symptoms
Probable Cause
B. No power to
C. Cable connections
D. PDS fuse is blown.
E. Media module is
F.
Cannot remove
A. Cables are twisting
2.
cables from
PDS box.
3.
Water is
A. Nozzle membrane
leaking from
around the
sprayheads.
Kohler Co.
Recommended Action
B. Verify media module
media module
is plugged in. Check
(media module
power to the outlet.
status LED is off).
C. Check cables and
to media module
connections, replace
are loose or
cables if necessary.
damaged.
D. Replace the PDS
fuse.
E. Contact a Kohler
not assigning an
Authorized Service
address to the PDS.
Representative.
PDS failure.
F.
Contact a Kohler
Authorized Service
Representative.
A. Unthread strain relief
when unthreading
cap only; then
strain relief
separate the rubber
connections.
stopper from the
strain relief body.
The strain relief body
will be free to
unthread from PDS
box.
A. Remove finished
is not seated
sprayface and verify
properly.
the nozzle membrane
is completely seated
in the groove in the
sprayhead. Refer to
the "Install the
Sprayhead" section.
25
1207716-2-C

Publicité

Table des Matières
loading

Table des Matières