Specific Safety Rules - Black & Decker LPP120 Mode D'emploi

Guard Against Kickback
KICKBACK may occur when the nose or tip of the
guide bar touches an object, or when the wood closes in and pinches
WARNING:
the saw chain in the cut. Tip contact in some cases may cause a
lightning fast reverse reaction, kicking the guide bar up and back
towards the operator. Pinching the saw chain along the top of the
guide bar may push the guide bar rapidly back towards the operator.
Either of these reactions may cause you to lose control of the saw
which could result in serious injury to user.
The following precautions should be followed to minimize
kickback:
• Grip Pole Saw firmly. Hold the saw firmly with both hands when the
unit is running. Use a firm grip with thumbs and fingers encircling
the saw handle and pole.
• Do not over reach.
• Keep proper footing and balance at all times.
• Don't let the nose of the guide bar contact a log, branch, ground or
other obstruction.
• Do not extend Pole Saw handle above shoulder height.
• Use devices such as low kickback chain, chain braking system and
special guide bars that reduce the risks associated with kickback.
• Only use replacement bars and chains specified by the
manufacturer or the equivalent.
• Never let the moving chain contact any object at the tip of the guide
bar.
• Keep the working area free from obstructions such as other trees,
branches, rocks, fences, stumps, etc. Eliminate or avoid any
obstruction that your saw chain could hit while you are cutting
through a particular log or branch.
• Keep your saw chain sharp and properly tensioned. A loose or dull
chain can increase the chance of kickback. Check tension at
regular intervals with the motor stopped and battery removed.
• Begin and continue cutting only with the chain moving at full speed.
If the chain is moving at a slower speed, there is a greater chance
for kickback to occur.
• Cut one branch at a time.
• Use extreme caution when re-entering a previous cut. Engage
spiked bumpers into wood and allow chain to reach full speed
before proceeding with cut.
• Do not attempt plunge cuts or bore cuts.
• Watch for shifting branches or other forces that could close a cut
and pinch or fall into chain.
Kickback Safety Features
The following features are included on your Pole
Saw to help reduce the hazard of kickback; however such features
WARNING:
will not totally eliminate this dangerous reaction. As a chain saw
user do not rely only on safety devices. You must follow all safety
precautions, instructions, and maintenance in this manual to help
avoid kickback and other forces which can result in serious injury.
• Reduced-Kickback Guide Bar, designed with a small radius tip
which reduces the size of the kickback danger zone on bar tip. A
reduced- kickback guide bar is one which has been demonstrated
to significantly reduce the number and seriousness of kickbacks
when tested in accordance with safety requirements for electric
chain saws.
• Low-Kickback Chain, designed with a contoured depth gauge and
guard link which deflect kickback force and allow wood to gradually
ride into the cutter. A low-kickback chain is a chain which has met
kickback performance requirements of ANSI B175.1 when tested
on the representative sample of chain saws.

SPECIFIC SAFETY RULES

• Hold tool by insulated gripping surfaces when performing an
operation where the cutting tool may contact hidden wiring.
Contact with a "live" wire will make exposed metal parts of the tool
"live" and shock the operator.
Some dust created by power sanding, sawing,
grinding, drilling, and other construction activities contains chemicals
WARNING:
known to cause cancer, birth defects or other reproductive harm.
4