Table des Matières
Publicité
2
Align assembly and install on door.
Let the wire hang on the other side, through the hole.
WARNING
Do not pinch ribbon cable!
WARNING
Ensure that the lever catch pin is aligned with latch side
before continuing!
The latch tails must fit inside the slide and the latch prongs
must fit into the chassis. If the latch tails are not at the proper
depth the door thickness ring needs to be adjusted.
See Door Thickness Adjustment.
Install Inside Assembly.
3
Install backplate first, then route ribbon cable.
CAUTION
Do not pinch ribbon cable!
Route cable through indicated space.
4
Install spring cage.
Align lever catch pin to door edge. Make sure the outside
escutcheon is square before tightening the bolts.
Lever Catch Pin
Actual Size
5
Install door position sensor.
5a
Press sensor into hole in edge of door and pull wire
through hole on door face.
Publicité
Table des Matières
