Connecting The External Control Terminal; Parallel Port; Rs-232C Terminal; Connecting Headphones - Denon DN-501C Mode D'emploi

Connecting the external control
terminal

Parallel port

Connect an external device to the parallel port.
Parallel control can be used to control DN-501C from an external
device.
For details on parallel control, see "Parallel Control" (vpage 43).

RS-232C terminal

Connect an RS-232C straight cable with a 9-pin D-sub connector to the
RS-232C serial terminal.
RS-232C control can be used for external control of the host device
and to configure settings.
For details on RS-232C control, see "RS-232C control" (vpage 37).

Connecting headphones

Connect the headphones to the headphone jack (PHONES).
When you press the headphone volume adjustment knob (
knob will spring out. After adjusting the volume, press the knob back
in again.
NOTE
To prevent hearing loss, do not raise the volume level excessively
when using headphones.
12 12

Connecting the power cord

Insert the power cord when all other connections are completed.
Be sure to connect the ground wire also.
To the power socket
(AC 120 V, 60 Hz)
LEVEL U.S.A. and Canada models
), the
To the power socket
(AC 230 V, 50/60 Hz)
European, UK and Asia/Pacific models
NOTE
• Be sure to insert the power plug firmly into the AC outlet. If the plug
is not properly inserted, it could cause malfunction or noise.
• Do not unplug the power cord while the unit is operating.
• Do not use a power cord other than the cord supplied with this unit.
Power cord
(provided)