Electrical Safety; Preparing For Commissioning; Preparation For Commissioning - ATIKA TOPTRONIC Mode D'emploi

Switch the machine off and remove the mains plug from
the socket when
− carrying out repair works
− carrying out servicing and repair works, removal of faults
(this also includes removing clamped splinters)
− Transporting the saw
− Changing the saw blade
− leaving the saw unattended (even during short
interruptions)
Look after your saw with care
− Keep the tools sharp and clean to be able to work better
and more safely
− Follow the servicing instructions and the information
about changing tools
− Keep handles dry and free of oils and grease
Check the machine for possible damage
− Before continuing to use the machine, the protective
devices must be inspected to ensure that they work
perfectly and with their intended function
− Check whether the movable parts function perfectly and
do not stick or whether the parts are damaged, All parts
must be correctly installed and fulfil all conditions to
ensure perfect operation of the saw
− Damaged guards and parts must be properly repaired or
exchanged by a recognized, specialist workshop; insofar
as nothing else is stated in the instructions for use.
Do not allow any tool key to be plugged in!
Store the unused machine in a dry locked place away from
the reach of children

Electrical safety

Design of the connection cable according to IEC 60 245 (H
07 RN-F) with a core cross-profile section of at least
1.5 mm for cable lengths up to 25m
2
2.5 mm for cable lengths over 25m
2
Protect yourself against an electric shock. Avoid touching
earthed parts with your body.
Do not use the cable for purposes for which it is not meant.
Protect the cable against heat, oil and sharp edges. Do
not use the cable to pull the plug from the socket.
Regularly check the saw cable and if damaged, have it
renewed by a recognised skilled electrician.
Regularly check the extension cables and replace them if
they are damaged
Do not use any defective connection cables
When working outdoors, only use extension cables
especially approved and appropriately labelled for outdoor
use
Do not set up any provisional electrical connections
Never bypass protective devices or deactivate them.
The electrical connection or repairs to electrical parts of
the machine must be carried out by a certified electrician or
one of our customer service points. Local regulations –
especially regarding protective measures – must be
observed.
Repairs to other parts of the machine must be carried out
by the manufacturer or one of his customer service points.
17
Use only original spare parts, accessories and special
accessory parts. Accidents can arise for the user through
the use of other spare parts. The manufacturer is not
liable for any damage or injury resulting from such action.

Preparing for commissioning

To achieve perfect function of the machine, follow the
notes given in these instructions
The saw set has been swivelled by 30° for transport
œ
place the saw blade in a vertical position (see page 8)
You have to attach the following parts:
Hand wheel handle
Protective guard (39)
Universal stopper
You will require the following tools
SW 10
First screw the hand wheel handle on. Turn it and then
œ
screw back again as shown in the picture.
The handle must still be able to be turned.
1. Using the hand wheel (21), turn the saw blade to its highest
position
2. Then pull out the splitting wedge (32) (fig. 13)
3. Assemble the guard (39)
SW 5
21
39