Transport; Storage; Guarantee; Possible Faults - ATIKA TOPTRONIC Mode D'emploi

•
Ensure that the saw blade remains free of rust and resin
•
Remove all resin residues from the saw bench top
•
The saw blade is a wearing part and becomes blunt after
long or frequent use
⇒ renew the saw blade or have it sharpened

Transport

Remove mains plug
before each transport
Only transport the saw with the traction cradles locked in
the end position, the saw blade lowered and lowered guard
This way you prevent damage to the locking technique and
injuries caused by the saw blade
For safe transport
Grip cut outs (C) are provided on all sides

Storage

Remove the mains
plug from the socket
Store unused equipment in a dry, locked place out of the
reach of children.

Possible faults

Fault
Machine fails to start after
switching on or switches off
during idle running
Machine stops while cutting
Workpiece sticks when
feeding
Burn marks at the cut edges • Saw blade is unsuitable for the cutting
Chip exit blocked
Height adjustment stiff
The motor is equipped with an electronic control, which keeps the cutting speed constant at each speed stage even when
loaded. Idle running, especially in low revolutions, can cause noise at gear which the operator may consider as unusual and
untypical for saws. This noise is absolutely normal and does not alt all affect the function.
21
Possible cause
• Power failure
• Extension cable defect
• Motor protecting switch has tripped –
right LED on the control panel is flashing.
• Motor or switch defect
• Saw blade sticks
• Saw blade blunt
• Feed too large
• Saw blade blunt
• Scale of the universal fence is not
parallel to the saw blade
task or blunt
• No exhaust suction connected
• Suction too weak
• Thread or guide plate soiled
To extend the service life of the saw and guarantee smooth
operation, before storing for a longer period
− thoroughly clean the saw
− treat all movable parts with an environmentally friendly oil

Guarantee

We grant a guarantee of two years, commencing with the day of
delivery from the dealer's store, for material and manufacturing
faults.
Warranty claims, even during the warranty period, will not be
accepted for damages due to incorrect handling or inadequate
packaging during return of the devices or to a non-observance
of the operating instructions.
Faulty parts must be sent to our works, postage or freight free.
We reserve the right to decide upon free spare part delivery.
Guarantee work will be completed by us or an authorised
servicing agency. Guarantee damage can only be remedied by
another firm with our explicit approval.
The guarantee does not cover normal wear to: saw blade,
protective hood, sliding body, bench profile, braking unit
Guarantee is also granted if original spare parts are used.
Subject to changes in the interest of technical progress.
Removal
• Replace fuse
• Check cable, no longer use defect cable
• Switch motor back on after cooling
"Motor protection", p 16
• Have motor or switch checked by an approved
electrician or replaced by original spare parts
• Remove bench profile section and remove cutting box
cover, remove cause
• Replace saw blade
• Allow motor to cool
• Hold the workpiece firmly and switch the motor off
immediately. The have the saw blade sharpened or
renew
• Readjust the scale
• Replace saw blade or have it sharpened
• Switch off saw and remove chips
• See "Safe working"
• Clean components and oil (p. 46, fig. 21, 22)
Never use any grease!