Prophete 2904 Notice D'utilisation page 30

Assembly
ASSEMBLING THE TOWING HITCH
1. Screw the towing hitch to the seat post of the pulling
bicycle (Fig. G). Depending on the diameter of the seat
post, use the supplied compensating bushings
where necessary. Firmly tighten the front screw of the
hitch (see chapter Torque specifications).
2
2. Align the rear part of the hitch parallel to the roadway
and firmly tighten the rear screw of the hitch
chapter Torque specifications).
3. Hitch the trailer to the bicycle (see chapter Hitching the bicycle trailer).
4. Check the clearance of the tow bar. If there is no clearance, then make individual
adjustments to the trailer equipment.
• Attach the towing hitch to the lowest possible point of the seat post.
This provides the best possible road holding and ensures the longest
possible longevity of the trailer and pulling bicycle.
HITCHING THE BICYCLE TRAILER
1. Loosen the fixing screw
side. (Fig. H).
2. Mount the tow bar to the hitch (Fig. H).
3. Turn in the fixing screw
4. Place the safety strap around the seat post of the
pulling bicycle and clip the snap hook into the eyelet
(Fig. J).
UNHITCHING THE BICYCLE TRAILER
1. Remove the safety strap
2. Loosen the fixing screw
side. (Fig. H).
2. Dismount the tow bar from the hitch.
30
BDA_2904__Fahrradanhänger_D_GB_F_I_NL_PL_H_RO.indd 30
and pull the shackle to one
1
completely (Fig. I).
1
from the seat post (Fig. J)
1
and pull the shackle to one
1
G
,
1
2
(see
3
H
I
J
1
3
1
1
1
18.12.2014 10:15:30