Tips On Energy Saving; Frost Protection; Storing Accessories - Siemens TE803 Série Mode D'emploi

Clean and refill water tank
start

● Rinse the water tank 11 and refill it with
fresh water up to the "max" mark.
● Press the start button 8. The descaling
programme now runs for about 1 minute
more, followed by the cleaning pro-
gramme for about 7 minutes, and rinses
the appliance.
Descaling
Cleaning
Empty drip tray
Replace drip tray
● Empty the drip tray 23 and reinsert it.
Replace the filter if one is being used.
The appliance has completed descaling and
cleaning and is ready for use again.
Important: Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue. Such residue can
cause corrosion. New sponge cloths may
contain salts. Salts can cause rust film
on stainless steel and must therefore be
washed out thoroughly before use.
Thoroughly clean the suction pipe 10d of
the milk frother.
Note: If one of the service programmes
is interrupted, e. g. by a power outage,
proceed as follows:
● Rinse the water tank 11 and refill it with
fresh water up to the "max" mark.
● Press the start button 8. The cleaning
programme now runs for about 3 minutes,
and rinses the appliance.
Cleaning
Empty drip tray
Replace drip tray
● Empty the drip tray 23 and reinsert it.
The appliance is ready for use again.

Tips on energy saving

● The display has a dimming function that
switches on automatically when the
appliance is not in use. The display is
illuminated dimly. Press any button or
the rotary knob to brighten the display
illumination again.
● If the appliance is not being used, switch
it off at the power on/off switch 1 O / I on
the front.
● If possible, do not interrupt coffee or milk
froth dispensing. Stopping a process
prematurely results in higher energy
consumption and the drip tray fills up
more quickly.
● Descale the appliance regularly to avoid
a build-up of limescale. Limescale residue
results in higher energy consumption.

Frost protection

¡ To avoid damage caused by frost
during transport and storage, the
appliance must be completely
emptied first.
See "Menu settings –

Storing accessories

The espresso machine has special com-
partments for storing the accessories and
quick reference guide inside the appliance.
● To store the measuring spoon 14, remove
the water tank 11 and insert the spoon in
the shaped recess 13.
● To store the quick reference guide, open
the door to the brewing unit 19 and stow
away the quick reference guide in the
storage compartment 22 provided for this
purpose.
"
Transport. lock.
en
49