RugDoctor FlexClean FCM-1 Manuel D'utilisation page 19

TROUBLESHOOTING
The following Troubleshooting Guide is provided to help you resolve issues that
may arise with common usage of the machine.
PROBLEM
›
›
NO POWER
›
›
NO / LOW SPRAY,
›
MACHINE
›
›
NO / LOW SPRAY,
UPHOLSTERY
TOOL
›
›
NO / LOW
SUCTION,
›
MACHINE
›
NO / LOW
SUCTION,
›
UPHOLSTERY
TOOL
›
ROTATING BRUSH
DOESN'T ROTATE
If you are not able to resolve or have other questions call the customer service
hotline at 1-800-784-3628.
r u g d o c t o r . c o m | 1 - 8 0 0 - 7 8 4 - 3 6 2 8
POSSIBLE REASON
Power Cord not plugged in
Power Button not turned on
Not pressing Cleaning Solution
Trigger
Clean Water Tank is empty or low
Clean Water Tank is not locked or
installed correctly
Valve of Clean Water Tank is clogged
Upholstery Tool Connection is not
installed properly
Dirty Water Tank Is full
Dirty Water Tank is not installed
correctly
Nozzle is not properly installed
Upholstery Tool Connection is not
installed properly
Kink or obstruction in Vacuum Hose
If something is lodged in the Brush
Roll, brush will stop rotating
HOW TO FIX
›
Plug Power Cord into wall outlet.
›
Press Power Button to "Floor Clean or
Upholstery" position.
›
Press and hold Cleaning Solution Trigger.
›
Fill Clean Water Tank with water and solution.
›
Lift up Clean Water Tank, and place back into
position. Tank should click into place when
positioned properly.
›
Remove valve from bottom of Clean Water Tank.
Clean with warm soapy water.
›
Disconnect plastic Upholstery Tool Connector
at end of the Upholstery Hose by pinching the
sides and pulling away from the base. Reconnect
Upholstery Tool Connector. You will feel the tool
lock into place.
›
Empty Dirty Water Tank and replace empty tank
when finished.
›
Lift up Dirty Water Tank and place back into
position.
›
Disconnect Nozzle. Reconnect Nozzle ensuring
the tabs are latched at the bottom and the latch
is fully engaged.
›
Make sure the Upholstery Tool Connection
is fully inserted into the Upholstery Tool port.
›
Unkink or remove obstruction in Vacuum Hose.
›
Turn machine off and unplug Power Cord from
outlet. Check that there is nothing stopping the
Brush Roll from rotating. The Brush Roll can be
removed by unlocking the cover with a coin or
screwdriver on the bottom of the machine.
Clean and check the Brush Roll spins freely.
Replace the Brush Roll and secure by locking
the Brush Roll cover. Then plug in the Machine
and turn the Machine on to continue cleaning.
19