RugDoctor FlexClean FCM-1 Manuel D'utilisation page 11

Operations:
cleaning your carpet
IMPORTANT CLEANING TIP:
CAUTION
1
Attach Carpet Nozzle
If the CARPET NOZZLE is not attached:
1. Align the nozzle tabs with the slots in the base of
the machine.
2. Rotate NOZZLE
3
toward machine
3. Latch the
NOZZLE by
pressing down
on the top of the
nozzle until you
hear a "click."
1
3
Plug In The Machine
Unwrap the POWER CORD
and insert plug into a properly
grounded outlet.
5
Turn Machine On
Push the POWER SWITCH to
"FLOOR CLEANING" position.
7
Cleaning Your Carpets
Press the SOAP & SCRUB TRIGGER
to apply solution.
Make 2 wet passes. (1 forward,
1 back) over each area.
* For heavily soiled areas, make
up to 4 wet passes
Release SOAP & SCRUB TRIGGER approximately 6
inches from stop point to ensure solution is removed.
r u g d o c t o r . c o m | 1 - 8 0 0 - 7 8 4 - 3 6 2 8
Vacuum area with dry vacuum cleaner thoroughly before deep cleaning.
Before plugging in machine, check the POWER SWITCH to make sure it is in
the "off" position.
2
Press
Soap &
Spray
Trigger
2
Select
Cleaning
Mode
Turn the FLOW
CONTROL DIAL to
the DEEP CLEAN or
QUICK DRY setting
based on desired
cleaning. Refer to
"Flow Control Dial"
instructions on PG 9.
4
Position The Machine
Position the MACHINE onto the
desired area to clean.
6
Release The Handle
Step on the HANDLE RELEASE
PEDAL to pull back/release the
MAIN HANDLE.
8
Leave The Machine On
For 15 Seconds
Leave the machine on for 15 seconds
after cleaning to allow for all of the
dirty solution to be collected into
the DIRTY WATER TANK.
Handle
Release
Pedal
11