Operations:
THE UPHOLSTERY TOOL
Great to use on Upholstery, Stairs, Mattresses and Spot Cleaning.
CAUTION
1
Remove The Nozzle
If attached, remove the Nozzle from the machine:
1. Press the NOZZLE
RELEASE BUTTON
to unlock the NOZZLE.
2. Rotate the NOZZLE
away from the base of
the machine to remove.
3
Selecting Cleaning Mode
Turn the FLOW
CONTROL DIAL to
the DEEP CLEAN or
QUICK-DRY setting
based on desired
cleaning.
(Refer to "FLOW
CONTROL DIAL" instructions for
additional details if needed, Page 9).
6
Position The
Upholstery Tool
Position the
UPHOLSTERY TOOL
in front of the area or
stain you want to deep
clean.
8
Step 2 - How To Clean
Release the SPRAY TRIGGER
Move the tool back and forth over
the same area to suck up dirty water.
r u g d o c t o r . c o m
|
1 - 8 0 0 - 7 8 4 - 3 6 2 8
Before plugging in machine, check the POWER SWITCH to make sure it is in
the "off" position.
Nozzle
Release
4
Plug In The
Machine
Unwrap the
POWER CORD
and insert plug
into a properly
grounded
outlet.
2
Attach The
Upholstery
Tool
Insert the
UPHOLSTERY
TOOL CONNECTOR in the
UPHOLSTERY TOOL PORT,
located behind the NOZZLE.
5
Turn The
Machine On
Push the POWER
SWITCH to the
UPHOLSTERY
CLEAN
position.
7
Step 1 - How To Clean
Squeeze the SPRAY TRIGGER on
the UPHOLSTERY TOOL to begin
cleaning.
Move the tool back and forth over the area you want
to deep clean. Make sure to press the top (suction)
nozzle down into the surface.
9
When You Are Done Cleaning
Leave the machine on for 15 seconds
after cleaning to allow for all of the
dirty solution to be collected into the
DIRTY WATER TANK.
Upholstery
Ports
13