Sequences Of Operation; Important - Napoleon P-E Série Instructions D'installation Et D'opération

44
6.2

SEQUENCES OF OPERATION

6.2.1 Heating Cycle
IOM
IOM
1. When thermostat switch is set to heat, the terminals R&W get connected which will energize the
indoor blower and all the relays for the heating elements immediately.
2. Relay 1, once energized, turns the first Heating element ON with up to 1 second delay. At the
same time Relay 2 powers the rest of the heating elements with delay range from 1 to 8 seconds
(applicable to 7.5 kW, 10kW, and 15 kW).
3. When the room thermostat is satisfied, terminal R and W connection opens and de-energizes all the
relays, blower and heating elements immediately.
6.2.2 Cooling Cycle
1. Room thermostat calls for cooling connecting R to Y terminals.
2. The compressor and condenser fan start immediately on a call for cooling. Air circulating fan also
starts immediately with cooling operation.
3. When the room thermostat is satisfied, terminal Y on the module is de-energized.
4. The compressor and condenser fan stop immediately when the thermostat is satisfied.
6.2.3 Continuous Fan Cycle
1. When thermostat switch is set to FAN, the terminals R & G get connected which will energize the
indoor blower to circulate the indoor air.
2. The indoor blower will continue to run until the thermostat setting is changed to different
operational mode.
CONTINUOUS FAN SPEED TAP SHOULD NOT BE CHANGED FROM FACTORY SETTING.
DO NOT USE COMMON SPEED TAP FOR MULTIPLE FUNCTIONS; IT CAN CAUSE UNIT TO
6.2.4 Performance Specification
W415-2288 / 08.29.2019
!
TABLE 5.
Model No.
BTU/h
P-E05A-A24A-A
24000
P-E07A-A24A-A
24000
P-E10A-A24A-A 24000
P-E15A-A24A-A
24000

IMPORTANT

MALFUNCTION.
COOLING
EER CFM
KW/h
4.8
11 800
7.3
11 800
9.6
11 800
14.4
11 800
!
HEATING
240V 208V
BTU/h KW/h BTU/h
16300 3.6 12300
24600 5.5 18400
32700 7.2 24600
49100 10.8 36900