Power Supply Installation - Napoleon P-E Série Instructions D'installation Et D'opération

5.1.3 Power Supply Installation

1
ELECTRICAL
SUPPLY SLOT
SUPPLY
OUTLET
HEATING
MODULE
FRONT PANEL
COOLING
SECTION
Locate the
electrical supply slot
on the top of cabinet enclosure.
Remove the access panels.
4
Install power supply cable:
1. Attach the cable to a strain relief connector. The strain relief connector must be certified and approved for
the required gauge per standard local and national electrical codes.
2. Insert the threaded end of the strain relief
into the electrical opening and pass the
supply cable through.
3. From the opposite end attach the
strain relief locknut onto the cable.
WARNING
!
RISK OF ELECTRICAL SHOCK !
DISCONNECT POWER BEFORE
INSTALLATION.
REPLACE BACK ALL ACCESS PANELS
BEFORE OPERATING. FAILURE TO DO SO
CAN RESULT IN ELECTRICAL SHOCK
CAUSING SEVERE INJURIES OR DEATH.
IT IS THE ELECTRICIAN'S
RESPONSIBILITY TO ENSURE THAT
THE WIRING AND CONNECTIONS
ARE COMPLIANT TO THE LATEST
EDITIONS OF THE CANADIAN
ELECTRICAL CODE
AND NATIONAL AND LOCAL CODES.
THESE INSTRUCTIONS ARE
INTENDED TO BE USED BY QUALIFIED
PERSONNEL ONLY, TRAINED IN
INSTALLING THIS TYPE OF UNITS.
Power Supply Cable
5
Strain relief
Lock Nut
Secure the strain
relief by tightening
the lock nut. The lock
nut should be tightened
with a tool (such as a pair of
pliers) to ensure the strain relief is
properly grounded to the fixture.
2
Large
Medium
SIDE
ACCESS
PANEL
Small
Reducing Cover Plates:
Based on cable gauge, determine the
reducer plate with right diameter size.
!
6
Connect power cables to
L1/L2 Distribution blocks.
3
Electrical Slot
Position the cover reducing plate
over the electrical slot and secure
the plate to the cabinet using ALL
three screws provided.
Power
7
cables
Ground lug
L1
L2
Connect main grounding cable to
ground lug.
29
Reducing Cover Plate
Power Supply Cable
Reducing Cover Plate
Strain relief Lock Nut
Power Cables
Ground wire
W415-2288 / 08.29.2019
IOM