Removing The Rechargeable Battery; Warranty And Support; Technical Specifications - Philips Lumea SC2009 Mode D'emploi

Recycling

Removing the rechargeable battery

Warranty and support

Technical specifications

Rated voltage
Rated frequency
Rated input
Protection against electric shock
Protections rating
Operating conditions
Storage conditions temperature
Relative humidity
Operating pressure
- Do not throw away the product with the normal household waste at the
end of its life, but hand it in at an official collection point for recycling. By
doing this, you help to preserve the environment.
Only remove the rechargeable battery when
you discard the appliance. Before you remove
the battery, make sure that the appliance is
disconnected from the wall socket and that the
battery is completely empty.
Take any necessary safety precautions when you
handle tools to open the appliance and when you
dispose of the rechargeable battery.
1 Check if there are screws in the back or front of the appliance. If so,
remove them.
2 Remove the back and/or front panel of the appliance with a screwdriver.
If necessary, also remove additional screws and/or parts until you see
the printed circuit board with the rechargeable battery.
3 Remove the rechargeable battery.
If you need information or support, please visit www.philips.com/support
or read the international warranty leaflet.
SC2009, SC2007
100 - 240 V
50 - 60 Hz
16 W
Class II, double insulated
IP 30 (EN 60529)
Temperature:+15 °C to 35 °C
-25 °C to 70 °C
Less than 90% (non condensing)
700 - 1060 hPa
English 25