Table des Matières
Publicité
Setting an indoor unit address and installation option
Setting the indoor unit option code
In order to set the indoor unit option code use the wired remote controller and follow the directions below.
Main Menu Sub-menu
Away/MDS
Press the
and
buttons at the same time for more than 3 seconds and then a Main menu will be displayed.
1. Press the
/
button to select
2. Press the
/
button to select
• The first digit represents the page number and the remaining five digits are option codes.
• The option code which is currently setting will flicker.
NOTE
3. Press the
/
button to set the option code in order. Press
4. Press the
button to save and complete the option setting.
5. Press the
button to exit to normal mode.
Press the
NOTE
• Option code will not be applied if you don't press the
• Setting indoor unit option code is only possible in Master wired remote controller. You can only check
CAUTION
the indoor unit option code in Slave wired remote controller.
• Setting indoor unit option code is possible when one indoor unit is connected. If more than 2 indoor
units are connected, you can only check the Master indoor unit option code.
AM072TNZDCH_IM_DVM V-AHU_AA_EN_.indd 33
Data bit
1 2 3
4
5
6
and then press
and then press
button to enter a Indoor unit option code setting screen.
button anytime during setup to exit without setting.
Option Code
Page number
1 2 34 56
SEG1
SEG2
SEG3
SEG4
0
*
*
Page number
SEG7
SEG8
SEG9
SEG10 SEG11 SEG12
1
*
*
Page number
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2
*
*
Page number
SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
3
*
*
Page number
button to enter a Sub-menu setting screen.
button to go to the next page.
SEG5
SEG6
*
*
*
*
*
*
*
*
*
*
*
*
English
33
2020-02-14 오전 10:33:38
Publicité
Chapitres
Table des Matières
