Setup Procedures; G Opening The Switch Pocket; G Turning The Power On/Off; G Channel Group Selection - Panasonic WX-CT2020 Manuel D'instructions

SETUP PROCEDURES

Caution: Setup of this product should only be performed
by qualified service personnel or system installers.

G Opening the Switch Pocket

1. Press the power button to turn off the order taker unit.
2. Open the switch pocket by moving the lid.
3. Set the channel selector and DIP switches. (Refer to
"Channel Group Selection" and "DIP Switch Setup".
4. After finishing the setup, close the switch pocket by
moving the lid.
5. Turn on the order taker unit.
Notes: Be sure to turn off the order taker unit in Step 1.
Otherwise, the channel group (refer to "Channel Group
Selection") will not be activated until you turn off and on
the power again.
w

G Turning the Power On/Off

1. Hold down the power button for two seconds to turn on
the order taker unit.
2. After using the order taker unit, hold down the power
button for two seconds to turn off the unit.
Hold down the power button for two seconds.
q

G Channel Group Selection

You can select a channel group by setting the channel
selector, which is the rotary switch inside the switch pocket.
1. Press the power button to turn off the order taker unit.
2. Set the switch to the channel group.
Available Channel Group: 1 - 8
Notes:
• When a switch position other than 1 through 8 is select-
ed, the power indicator will blink in red.
• Be sure to turn off the order taker unit in Step 1.
Otherwise, the channel group will not be activated until
you turn off and on the power again.
1 2 3 4 5 6 7 8
G
5 6
7
4
8
3
2
1
Channel selector

G DIP Switch Setup

An eight-bit DIP switch is provided for system setups. The
initial settings are marked with an asterisk *.
Note: Be sure to turn off the order taker unit in Step 1.
Otherwise, the channel group (refer to "Channel Group
Selection") will not be activated until you turn off and on
the power again.
SW# Function
1 Location
2
3
4
5
6 Tone Squelch
7 Talk Lock Resumption
8
1. Press the power button to turn off the order taker unit.
2. Set the switches as follows.
SW#1: For selection of a radio frequency suitable for
the location
ON: Applies the US frequency to the headset.
OFF: Applies the Canadian frequency.
ON OFF
USA* Canada
OFF*
OFF*
OFF*
OFF*
ON* OFF
ON OFF*
OFF*
7