GYS NOMAD POWER 300 Mode D'emploi page 12

Translation of the original instructions
PROTECTIONS
This device is protected against overload, overheating, overintensity, deep discharge, short circuit and polarity reversal.
TROUBLESHOOTING, CAUSES, SOLUTIONS
TROUBLESHOOTING
No answer while pressing the ON/
1
OFF button
Error» light fixed on the smart start
2
Error» indicator flashes
+ discontinuous beeper.
Error» indicator flashes
+ continuous sound signal
3
Error» indicator flashes
+ quick beep.
Fixed «Start» light
+ «Error» light fixed.
WARRANTY
The warranty covers faulty workmanship for 1 year from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
12
NOMAD POWER 300 / 400
The NOMAD POWER is discharged.
Internal battery voltage < 11.0V.
cable.
Short circuit.
Reverse polarity.
Overheating.
The clamps have been connected
to the battery for more than 30
seconds.
CAUSES
Charge the product.
Charge the product.
Check that the clamps are properly
connected and disconnect/reconnect
the smart start cable.
Check that the clamps are properly
connected and disconnect/reconnect
the smart start cable.
Disconnect the clamps from the bat-
tery and the NOMAD POWER and
wait 5 minutes then reconnect.
Remove the 2 clamps from the
vehicle battery terminals to protect
the unit.
EN
SOLUTIONS