Operation - Meister EF600M Traduction Du Manuel D'utilisation Original

suitable diamond discs for wet cut-
ting. The choice of disc depends on
the material to be cut, so always fol-
low the maker's instructions.
Mounting of the protective hood
Place the protective hood (1) onto
the splitting wedge and align. Attach
the protective hood (1) to the splitting
wedge using the screw and attachment
screw (12).
Parallel stop
The parallel stop (10) enables cuts to
be made lengthways along the work-
piece. For this simply set at the desired
distance from the cutting disc, using the
scale for parallel cuts (3).
Angle stop
For this secure the parallel stop (10) on
the other side of the cutting wheel and
set the angle stop (11) on the rail.
Mitre setting
The adjustable work plate
enables mitred cuts at angles
of up to 45 o to be made. To
obtain the desired mitre undo the two
screws (6) to the right and left of the
work plate. Set the mitre and do up the
screws.
8 – Operation
The unit is provided with a residual
current circuit-breaker integrated in the
mains plug (Fig. 4), which prevents the
motor from starting uncontrolled when
putting into operation, after power fail-
ure or short-circuit.
• Insert the plug into a power socket.
5461060-Fliesenschneidemaschine-man.indd 37 5461060-Fliesenschneidemaschine-man.indd 37
ATTENTION! Prior to putting into
operation, a functional test must
always be conducted:
- Press the green button (top): The
integrated residual current safety
fuse must be able to be audibly
deactivated.
- Press the yellow button (bottom):
The integrated residual current safe-
ty fuse must be able to be audibly
activate.
ATTENTION! As soon as the
residual current safety fuse is
activated, the pilot lamp (L) comes on.
It goes out with a short-circuit, power
failure or when the mains plug is
pulled.
ATTENTION! Without prior func-
tional test, the unit cannot be
switched on! Only after the functional
test has been conducted is the unit
ready for operation.
Activate the green button on the
residual current circuit breaker.
• To switch on: Press On/Off switch (8)
to (l).
• To switch off: Press On/Off switch (8)
to (O).
ATTENTION! With any functional
disturbance or shutdown, press
the On/Off switch (8) on the unit to
„0" to prevent the motor from starting
uncontrolled.
37
29.10.20 07:53 29.10.20 07:53