Operation; Maintenance And Environmental Protection - Meister EF600M Traduction Du Manuel D'utilisation Original

screws (6) to the right and left of the
work plate. Set the mitre and do up the
screws.
8 – Operation
The unit is provided with a residual
current circuit-breaker integrated in
the mains plug (Fig. 4), which prevents
the motor from starting uncontrolled
when putting into operation, after power
failure or short-circuit.
• Insert the plug into a power socket.
ATTENTION! Prior to putting into
operation, a functional test must
always be conducted:
­ P ress the green button (top): The
integrated residual current safety
fuse must be able to be audibly
deactivated.
­ P ress the yellow button (bottom):
The integrated residual current
safety fuse must be able to be
audibly activate.
ATTENTION! As soon as the
residual current safety fuse is
activated, the pilot lamp (L) comes on.
It goes out with a short-circuit, power
failure or when the mains plug is
pulled.
ATTENTION! Without prior
functional test, the unit cannot
be switched on! Only after the
functional test has been conducted is
the unit ready for operation.
Activate the green button on the
residual current circuit breaker.
36
MW-5461060-Bedien-2005.indd 36 MW-5461060-Bedien-2005.indd 36
• To switch on: Press On/Off switch (8)
to (l).
• To switch off: Press On/Off switch (8)
to (O).
ATTENTION! With any functional
disturbance or shutdown, press
the On/Of switch (8) on the unit to
„0" to prevent the motor from starting
uncontrolled.
9 – Mode of operation
Cutting tiles
Cut with the decorated side upward.
Always use a light but even pressure when
pressing the work-piece against the blade
edge, even if the resistance increases.
Do not run the tool for long
S2 : 10 min
periods at a time. To avoid
overheating the tool should not be kept
switched on for longer than 10 minutes at
a time. Allow the tool to cool down
between whiles.
10 – Maintenance and
environmental
protection
WARNING! Pull out power plug.
After use clean the tool with a damp
cloth only. Empty and clean the water
reservoir. Treat non-stainless parts with
an anti-corrosive agent.
CAUTION! Electrical and battery
operated units that no longer work
should not be disposed of in the house-
hold waste! They are to be collected
separately, in accordance
13.05.20 11:02 13.05.20 11:02