golmar Vista Nexa Manuel D'installation page 111

110
P
rogramming the T-730/R5 telephones.
Locate the configuration dip switch placed
the sound module
The door panel will emit a tone which indicates that it's in programming mode.
In systems with more than one door panel, the programming process shall be
done on the master door panel only.
Master
Each apartment must have one master unit only; in case of parallel units configure
them as slaves, whether they are monitors or telephones.
IMPORTANT:
If the installation has a CD-PLUS/R5 converter with coded door panel or porter's exchange, the
programming codes assigned to the telephones must be between 1 and 250. To make it easier for
the user to make a call, can assign in a parallel manner another code in a 2 assignment chart
(see manual: T-590ML
TELEPHONES PROGRAMMING
at the upper right side of the back of
and set number 2 to ON, as described on page 99.
With the door release push button pressed, lift the
handset off the telephone.
To show that the system is ready for programming, the
door panel and handset will emit a tone, and audio
communication can be established.
Release the door release push button.
With the handset lifted:
If programming the telephone as master, replace the
If programming it as slave, press the door release
Slave
Make a call to check that the telephone has been successfully programmed.
Repeat these steps to program the rest of telephones.
Once the programming has been finished, set to OFF the programming
switch. If you don't, the door panel will reproduce a sound to advise that
the system is still into programming mode.
porter's exchange
Press the door panel push button that will
call to this telephone.
At this moment both door panel and
handset will emit tones.
handset.
push button, then replace the handset.
or T-3403ML coded door panel
nd
).