golmar Vista Nexa Manuel D'installation page 100

DOOR PANEL INSTALLATION
D
escription of the SW1 configuration dip-switch of
the sound module.
The SW1 configuration dip-switch is located at the upper right
side of the back of the module.
For dip switch settings, use the tool
sound module.
that is supplied with the
Switch number 1 allows the autoswitch-on function (audio and video
communication without previous call) at the door panel that has this
switch set to the ON position In buildings with several door panels,
activate only one of them In systems with a general entrance door
panel this function can be activated in one door panel of each
building .
Set to ON the switch number 2 for monitor or telephones programming
Once the programming is finished return the switch to the OFF
position The programming process is described on pages 107 .
(monitors) and 110 (telephones)
Set to OFF the switch number 3 in case of a master door panel Each
system must have only one master door panel; the rest must be slaves
(ON). In systems with general entrance panel set as master one door
panel of each internal building
Set to ON if the door panel has telecamera Set to OFF if the door panel
doesn't have telecamera.
Set to ON
only on one door panel in each installation
has more accesses, set the rest to OFF
Set to ON to divert calls from the door panel to the porter's exchange
when the latter is active, set to OFF if this function is not desired
(Requires the use of the
door panel capture is activated in the porter's exchange
Set to ON so that the tone volumes emitted by the door panel are
or set to OFF if a
NORMAL
Not used .
.
.
.
.
.
digital converter and that the
CD-PLUS/R5
tone volume is desired
*Factory default
99
.
.
, if the building
).
,
HIGH
.