Install The Hood - Best WPD28I Guide D'installation

5. INSTALL TRANSITION
Attach transition (provided) to top of hood.
Use duct tape to make all joints secure and airtight.

6. INSTALL THE HOOD

Lift hood up and onto wood strip. Attach transition to
10" round duct. Center hood over location and hold it
up against bottom of soffit or flue. Secure hood to
wood strip with provided no. 8 x 3/4" mounting screws.
Use additional mounting screws (and wall anchors if
necessary) through lower set of holes.
7. CONNECT DECORATIVE FLUE TO HOOD
AEWPD Series
From inside the hood, attach flue to top of hood at sides and front of hood
using no. 8-32 x 1/2" screws (provided with decorative flue).
If this decorative flue is installed in a saline environment
(e.g. coast), rinse all surfaces once a week with clear water,
(even if the hood is not used) and wipe dry completely.
HD0140
CAUTION
- 6 -
T
RANSITION
D
UCT TAPE
O
UTSIDE TOP OF HOOD
HD0057
I
NSIDE TOP OF HOOD
M
OUNTING SCREWS LOCATIONS
A
DDITIONAL MOUNTING
SCREWS LOCATIONS
HD0060
(OPTIONAL)
I
NSIDE TOP OF HOOD