Astralpool VICTORIA PLUS SILENT VS Manuel page 6

Masquer les pouces Voir aussi pour VICTORIA PLUS SILENT VS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNINGS DURING INSTALLATION AND ASSEMBLY WORK
- Only in cases of terminal box connections, when connecting the electrical wiring to the machine motor,
check the layout inside the connection box and make sure there are no pieces of wiring inside after it has
been closed and that the earthing conductor is correctly connected. Connect the motor in line with the wiring
diagram attached to the machine.
- Only in cases of terminal box connections, make sure that the electrical wiring connections to the machine
terminal box are well mounted and screwed tight to the connection terminals.
- The equipment should be connected to an alternating current supply (see data on the pump's plate) with
earth connection, protected by a residual current device (RCD) having a rated residual operating current not
exceeding 30 mA.
- Correctly use the seal of the terminal box for the electrical motor to prevent water getting in. Likewise,
position and tighten the gland inside the cable duct of the terminal box.
- Make sure that water is unable to enter the motor or the live electrical parts.
- Where the intended use is not as indicated, additional technical adaptations and regulations may be required.
WARNINGS DURING START-UP
- Before starting the machine, check the calibration of the electric protection devices on the motor and that the
protection against electrical and mechanical contacts is correctly positioned and secure.
NOTE
The pool should not be used while the pumping equipment is running.
Do not use the pump if anyone is in contact with the water.
WARNINGS DURING ASSEMBLY AND MAINTENANCE WORK
- Take into account national installation regulations when assembling and installing the pumps.
- Make sure that water is unable to enter the motor or the live electrical parts.
- Avoid contact at all times - even accidentally - with moving machine parts while the machine is running
and/or before it comes to a complete standstill.
- Wait for the machine to come to a halt before handling it.
- Before any electrical or mechanical maintenance operation, disconnect the unit from the power supply and
block the startup devices.
6
Victoria Plus Silent VS
- ASTRALPOOL

Publicité

Table des Matières
loading

Table des Matières