Setting The Temperature; Setting The Display Brightness - Dometic CFF Série Notice D'utilisation

CFF35, CFF45
Latching the cooler lid
➤ Close the lid.
➤ Press the latch (fig. 2, page 9) down, until it latches in place audibly.
I
NOTE
When latching the lid, ensure that both latch side pins are fully engaged
to ensure a good lid seal. One latch may engage slightly before the
other.
➤ If the lid is not closed equally at both sides, press until a second click
is heard.
7.6

Setting the temperature

➤ Press the "SET" button (fig. 3 5, page 10) once.
➤ Use the "UP +" (fig. 3 7, page 10) and "DOWN –" (fig. 3 6, page 10) buttons
to select the cooling temperature.
✓ The cooling temperature appears in the display for a few seconds. The display
flashes several times and then the current temperature is displayed again.
7.7

Setting the display brightness

The display brightness can be dimmed for low ambient light conditions. To set the
dimming level of the display proceed as follows:
➤ Switch on the cooler.
➤ Press the "SET" button (fig. 3 5, page 10) four times.
➤ Use the "UP +" (fig. 3 7, page 10) or "DOWN –" (fig. 3 6, page 10) buttons to
set the brightness of the display.
✓ Display will be as follows:
d0 (default), d1 (medium), d2 (dark)
✓ The display shows the set mode for several seconds. The display flashes twice
before it returns to the current temperature.
I
NOTE
• The factory setting of brightness of the display is d0 (default).
• If a fault occurs, the brightness automatically reverts to brightness d0
(default). After troubleshooting the set brightness is reactivated.
EN
Operation
19