Installation - Indesit IS5E4KHW/MEA Manuel D'utilisation

INSTALLATION TIPS INSTALLATION TIPS INSTALLATION TIPS INSTALLATION TIPS INSTALLATION TIPS INSTALLATION TIPS
Using the oven
The first time you use your appliance, heat the
empty oven with its door closed at its maximum
temperature for at least half an hour. Ensure that the
room is well ventilated before switching the oven off
and opening the oven door. The appliance may emit
a slightly unpleasant odour caused by protective
substances used during the manufacturing process
burning away.
1. Select the desired cooking mode by turning the
SELECTOR knob.
2. Select the recommended temperature for the
cooking mode or the desired temperature by turning
the THERMOSTAT knob.
A list detailing cooking modes and suggested
cooking temperatures can be found in the relevant
table ( see Oven cooking advice table ).
During cooking it is always possible to:
• Change the cooking mode by turning the
SELECTOR knob.
• Change the temperature by turning the
THERMOSTAT knob.
• Set the total cooking time and the cooking end
time ( see below ).
• Stop cooking by turning the SELECTOR knob to
the "0" position.
Never put objects directly on the bottom of the
oven; this will avoid the enamel coating being
damaged.
Always place cookware on the rack(s) provided.
THERMOSTAT indicator light
When this is illuminated, the oven is generating
heat. It switches off when the inside of the oven
reaches the selected temperature. At this point the
light illuminates and switches off alternately,
indicating that the thermostat is working and is
maintaining the temperature at a constant level.
WARNING : This operation must be perfomed
by a qualified technician
Oven light
This is switched on by turning the SELECTOR knob
to any position other than "0". It remains lit as long
as the oven is operating. By selecting
knob, the light is switched on without any of the
heating elements being activated.
TABLE OF CHARACTERISTSICS
Oven max. power
absorption
Voltage and
frequency
Electric Hob
ENERGY LABEL
and ECODESIGN
Data plate, is located inside the flap or, after the oven
compartment has been opened, on the left-hand wall
inside the oven.
with the
WARNING! The oven is
provided with a stop sys-
tem to extract the racks
and prevent them from
coming out of the oven.(1)
As shown in the drawing,
to extract them comple-
tely, simply lift the racks,
holding them on the front
part, and pull (2).
2250 W
see data plate
Electric hob
Front left 1500 W
Back left 2000 W
Back right 1500 W
Front right 2000 W
Maximum absorption
of the electric hob 7000 W
Energy consumption for Natural
ECO
convection – heating mode:
EN
17