brennenstuhl SOL SV0805 P1 IP 44 Mode D'installation Et D'emploi page 7

043413 SOL SH_LH Doppelstrahler 08.03.16 12:13 Seite 7
Fig. 6
Solar Module:
The solar module is the main power source of the solar light. It
converts sunlight into electricity and charges the batteries.
Please keep in mind when installing the solar module that the
photovoltaic cell works best in DIRECT SUNLIGHT. The longer
the photovoltaic cell is exposed to direct sunlight, the longer
the light can be used. Ideally, the solar module should face
south in order to capture direct solar radiation. Avoid shade of
any kind. For Central Europe, we recommend an angle of
approx. 30º - 40º. Use the screws included in the package
(item 3 of the parts list) to install the solar module on a firm
surface, such as a wall. Use screws and screw anchors that are
suitable for the installation surface.
Fig. 8
Fig. 9
Fig. 7
Fig. 10
7
Fig. 11
Position the cable between the photovoltaic cell and the main
unit and connect the cable of the main unit with that of the
photovoltaic cell by connecting the plug and the socket.
ADJUSTMENT AND INITIAL OPERATION
After successful installation of the solar light the device can be
adjusted in a few simple steps.
Important:
Make sure the solar light has been charged as described
under "Charging the Solar Light for the First Time" before
the light is switched on.
The main unit features a switch with two settings:
ON: Setting used with the motion detector.
OFF: Switches off the motion detector feature / LED light.
Setting used for charging.
Adjusting the Motion Detector
Switch the button to the ON position after initial charging has
been completed. Point the motion detector in the direction you
wish to monitor. Set the adjustment knob on the back side of
the motion detector to "Minimum" (-) and the LUX adjustment
knob to "Light" ( ). Test the detection range by slowly circling
the area to be monitored. If the solar light does not light up as
desired the angle of the motion detector must be adjusted.
The motion detector has two adjustment knobs:
TIME LUX
(TIME) = light ON time: The length of time the light remains
on after a movement has been detected can be adjusted to
anywhere between approx. 10 seconds and 1 minute. Turn the
Fig. 12