Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Stacking.
INSTALLING THE STACK BRACKET KIT (cont.)
Place
hands
here
4. Prepare the Washer and
Dryer
A. Place the washer in the approximate
location.
B. Make sure the washer is level.
Refer to washer Installation
Instructions for details.
5. Install Dryer and Bracket on
Washer
A. Lift the dryer on top of the washer.
Be careful not to scratch the top
of the washer with the brackets.
Protect the washer control panel
with cardboard or other protection.
Be sure to lift the dryer high enough
to clear the washer control panel.
WARNING!
Potential Personal Injury. More than
two people are recommended to lift
the dryer into position because of its
weight and size. Failure to do so could
result in personal injury or death.
6. Finalize the Installation
A. Refer to the washer Installation
Instructions to complete the washer
installation.
B.
R
f e
r e
o t
h t
e
d
y r
Instructions to complete the dryer
Place
installation.
hands
here
C.
C
a
e r
u f
y l l
s
d i l
e
washer and dryer into place. Use felt
pads or other sliding device to assist
moving and to protect flooring.
C. Reverse dryer door swing if desired.
B.
Potential Personal Injury. Do not push
on the dryer once installed to top of
the washer. Pushing on the dryer may
r e
n I
t s
l l a
t a
o i
n
result in pinched fingers.
r o
w
a
k l
h t
e
t s
c a
e k
d
See dryer Installation Instructions
for details.
NOTE: The washer door swing is not
reversible.
A
g i l
n
h t
e
h
l o
s e
n i
h t
e
b
a r
k c
the holes in the back of the washer.
Using a Phillips screwdriver, attach
the 2 #8 x 1/2" tapping screws.
Repeat on both sides of the washer.
WARNING!
t e
i w
h t
37
Publicité
Table des Matières
