GE GFMN110 Manuel D'installation page 22

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

About the dryer control panel.
1
Power
Press to "wake up" the display. If the display is active, press to put the dryer in the standby mode.
NOTE: Pressing Power does not disconnect the appliance from the power supply.
Dry Cycles
2
The dry cycle controls the length and tumble speed of the drying process. The chart below will help you match
the dry setting with the loads.
Sensor Cycles
Normal Mixed Load
Cottons
Bulky Bedding
(on some models)
Easy Care
(on some models)
Delicates
Speed Dry
Timed Dry Cycles
Warm Up
(on some models)
Air Fluff/No Heat
DeWrinkle/Full Loads
(on some models)
Steam DeWrinkle/
Full Loads
(on some models)
My Cycle
My Cycle
(on some models)
3
Time Dry
Use to set your own dry time. Time Dry is also recommended for small loads
To use Time Dry:
1. Turn dry cycle dial to Time Dry.
2. Increase the drying time by pressing the Time Dry button.
Note: This button only increases the time. When max time is reached, pressing the button again will reset
the counter to the lowest setting.
3. Select the Temp.
4. Close the door.
5. Press Start.
22
Description
For loads consisting of cottons and poly-blends.
For cottons and most linens.
For large coats, bed spreads, mattress covers, sleeping bags and similar large and bulky
items. Large items such as blankets, comforters, jackets and small rugs.
For wrinkle-free and permanent press items.
For lingerie and special-care fabrics
For small loads that are needed in a hurry, such as sports or school uniforms. Can also be
used if the previous cycle left some items damp, such as collars or waistbands.
Description
Provides 10 minutes of warming time to warm up clothes.
Use this feature to tumble items without heat.
For removing wrinkles from items that are dry or slightly damp. This cycle is not
recommended for delicate fabrics.
For slightly wrinkled dry garments. Significantly reduces wrinkles on garments. After this
cycle, the unit will beep and display "0:00." If the unit is not turned off or if the door is not
opened, the dryer will continue to tumble for 30 minutes. At the end of 30 minutes, it will
display "0:00" and the cycle will be complete.
Note: A single extremely light fabric item may need to have an additional item included in
the cycle to achieve optimum results.
Description
Press to use, create or modify custom dry cycles. (See the My Cycle section for more details)
www.GEAppliances.ca

Publicité

Table des Matières
loading

Table des Matières