GE GFMN110 Manuel D'installation page 20

Installation Instructions / Gas Dryer
ADDING ELBOW FOR EXHAUST
THROUGH BOTTOM OF CABINET
Insert the elbow through the rear opening and connect it to the
dryer internal duct.
Apply duct tape on the joint between the dryer internal duct
and elbow, as shown on page 7.
CAUTION:
Internal duct joints must be secured with tape,
otherwise they may separate and cause a
safety hazard.
ADDING COVER PLATE TO REAR OF
CABINET
PLATE
(KIT WE1M454)
Connect standard metal elbows and ducts to complete the
exhaust system. Cover back opening with a plate (Kit
WE1M454) available from your local service provider. Place
dr
WARNING - NEVER LEAVE THE BACK
OPENING WITHOUT THE PLATE.
20
RESIDENTIAL GARAGE INSTALLATION
13
Dryers installed in residential garages must be
elevated 18 inches (46 cm) above the floor.
SERVICING
14
TO DISCONNECTING WHEN SERVICING
CONTROLS. WIRING ERRORS CAN CAUSE
IMPROPER AND DANGEROUS OPERATION
AFTER SERVICING/INSTALLATION.
For servicing phone numbers for replacement parts, and other
information, refer to Owner's Manual or visit our Web site.
(Kit WE1M454)
WARNING -