Working Without The Automatic Leveller; Working With The Clamp Tripod; Working With The Tripod; Cleaning - Parkside PKLL 7 B2 Traduction Des Instructions D'origine

G B I E
4. Switch the device off by
locking the levelling stop:
position
In the event of vibrations,
the laser will level itself auto-
matically; wait until the laser
lines no longer move.
Working without the
automatic leveller
Caution! - Laser beam.
Do not look into the
beam. Turn your head
away or close your eyes
to prevent looking into the
laser beam.
Danger of eye injury!
The LED ring (2) will illu-
minate permanently in red
when working without the
automatic leveller. The la-
ser lines depicted are not
levelled.
Switching on:
Turn the device on using the on/
off switch (1). The levelling stop
(4) must be in position
Switching off:
Turn the device off using the on/
off switch (1).
Working with the clamp
tripod
The clamp tripod provided can
be used to attach the device to
various objects.
1 8
.
.
1. Release the clamping nut
(9).
2. Position the clamping jaws
(10) to the desired location.
3. Turn the clamping nut (9)
until fastened.
4. Place the device with thread
(5) onto the tripod screw (7)
and tighten by hand.
Do not use excessive force
as this may damage the de-
vice.
5. Align the device. To do so,
release the retaining screw
(8) and move the device into
the desired position.
6. Fix the position by fastening
the retaining screw (8).

Working with the tripod

You can place the device in a
stable position and adjust the
height using a tripod (not provi-
ded in scope of delivery).
Place the device with thread (5)
onto the tripod screw and tigh-
ten by hand.
Do not use excessive force as
this may damage the device.

Cleaning

Have any work on
the device that is
not described in this
instruction guide
performed by a pro-
fessional. Only use
original parts.