Hansgrohe AXOR Starck 10407 1 Série Instructions De Montage / Mode D'emploi / Garantie page 16

1
Ø
1
1
4 mm
2
2
3
4
2
English
Reverse the cartridge
If the valve opens through hot, reverse the
cartridge.
Close the stops using a 4 mm Allen
wrench, or turn the water off at the
main (1).
Unscrew the nut (2).
Place the handle on the cartridge stem.
Turn the handle counter-clockwise approximately
¼ turn after hitting the stop.
Remove the cartridge (1).
Do not attempt to pry the cartridge
from the function block by using
a screwdriver, or damage to the
cartridge will result.
Turn the cartridge 180°, so that the "hot side"
marking is on the right (2).
Install the cartridge (3)
Install the nut (4).
Continue the installation.