Evolution EVOMAG 28 Manuel D'utilisation page 29

www.evolutionpowertools.com
of travel. The cutting head must not move
downward under its own weight, but must
have to be raised or lowered by the operator
using the feed handles.
MACHINE No. Of adjustment
EVOMAG28
EVOMAG50
EVOMAG75
• All of the adjustment screws and associated
lock nuts are located along the Right Hand
edge of the machine's main slide.
• Use an 8mm AF wrench to loosen slightly the
locknuts which lock the adjustment screws in
place.
• Use a hex key, and starting with the lowest
adjusting screw, work upwards turning the
adjustment screws slightly so that to any free
sideways movement of the slide is eliminated.
• Turn the feed handles to move the slide and
cutting head up and down. There should be no
free play, but no binding anywhere throughout
the range of travel.
• If necessary, repeat the above procedure
several times to ensure that any free play or
movement has been eliminated.
• As the feed handles are operated, the
machines cutting head and slide should move
up or down freely without any binding and
without any side to side movement
• When adjustment has been successfully
completed, retighten the locknuts.
• Recheck the movement of the machines slide
and cutting head.
screws
7
5
5
29
EN
ES
FR