Evolution EVOMAG 28 Manuel D'utilisation page 21

www.evolutionpowertools.com
operations.
• The information contained within the chart (page 20) is given
as general guidance only, and reference should be made to any
information supplied by the cutter manufacturer.
WARNING: Never attempt to change gear whilst the machines
arbor is rotating. The motor should be switched 'off' and it and the
arbor must be completely stationary.
EVOMAG75
Note: It is recommended that the speed required is set before the
machine is connected to the power supply.
The EVOMAG75 has a four (4) speed gearbox. The set speed is
determined by the position of the two (2) sliding gear selection
buttons. (Fig. 4)
• Consult the information diagram/sticker found at the front of the
machine. (Fig. 5)
• Push in the spring loaded selector button(s) and slide to the
required position.
• The pictogram on the information diagram/sticker show the
relative position of the two (2) selector buttons for all the speeds
available.
Note: To aid gear selection and to ensure that the gears mesh
correctly, it may be helpful to turn the machine's arbor whilst sliding
the selector buttons.
ROTATIONAL DIRECTION
EVOMAG75
This machine is equipped with a 3 position switch (Fig. 6)
which allows the operator to select the rotational direction of the
arbor. The middle position is 'neutral', up is forward and down is
reverse.
WARNING: Be aware that if the motor is switched on with
the switch in the 'neutral' position, the machine will not rotate,
but will be 'live'. As soon as forward or reverse is selected the arbor
will begin to rotate.
FIG. 4
NO LOAD R.P.M
FULL LOAD R.P.M
200
120
260
150
390
230
490
290
FIG. 5
FIG. 6
21
EN
ES
FR