Gear Selection Page 20; Pre Use Testing - Evolution EVOMAG 28 Manuel D'utilisation

FIG. 7
FIG. 8
EVOMAG75 shown above.
Others machines are very similar.
FIG. 9
EVOMAG75 shown above.
Others machines are very similar.
GEAR SELECTION
EVOMAG50
The EVOMAG50 has a two (2) speed gearbox. The set speed is
determined by the position of the sliding gear selection button.
(Fig. 7)
Note: To aid gear selection and to ensure that the gears mesh
correctly, it may be helpful to turn the machines arbor whilst
sliding the selector button.
WARNING: Never attempt to change gear whilst the machine's
arbor is rotating. The motor should be switched 'off' and it and
the arbor must be completely stationary.
• Push in the spring loaded selector button and slide to the
required position.
• The information contained within the chart below is given as
general guidance only, and reference should be made to any
information supplied by the cutter manufacturer.
GEAR No Load
RPM
1 380/230
2 500/300

PRE USE TESTING

ALL MACHINES
WARNING: These machines have Class 1 insulation and
must be earthed. Any power socket that these machines
are connected to must be grounded to earth. Ensure that all
operating switches are in the 'OFF' position before connecting
the power cord to a socket.
WARNING: The power cord assembly is a custom terminated
one. Replacement should only be carried out by a qualified
technician. Use only replacement parts recommended by
Evolution Power Tools.
WARNING: Do not perform any testing with a cutter, drill or tap
installed in the machine.
• Place the machine onto a piece of clean 10mm thick mild steel
plate that is larger than the magnetic base of the machine.
• Connect the plug into a mains supply outlet.
• Place the red rocker switch in the "on" position to energize the
magnet. (Fig. 8)
22
www.evolutionpowertools.com
CUTTERS
1-9/16" - 2"
(40mm - 50mm)
1-9/16"
(40mm or less)