Fcc Statement - Dali ZENSOR AX Manuel

C O N T E N T S / I N H A LT / I N D H O L D / C O N T E N u / 内 容
ENGLISH
DEutScH
DANSK
frANçAIS
日本
• Connect the speakers with the included speaker cable (see part 4.0 - 4).
• Connect the left speaker to mains power and turn on the power switch on the back.
• Change to Bluetooth mode using the remote control, or source select on the back of the left speaker.
• Locate DALI ZENSOR AX in your playback device's Bluetooth device list and establish the connection.
• Start playback on your playback device.
• To achieve optimal audio quality, set the playback device's volume to maximum and use the speaker
volume buttons to control the volume.
• The ZENSOR AX will automatically reconnect to the last connected devices.
• Any existing connection must be disconnected before a new connection can be made.
• To disconnect a Bluetooth connection, use the Release button on the remote or the Release combination
on the back of the left speaker.
• Read more about ZENSOR AX Bluetooth mode in part 5.2

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
IC Caution
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body.
CAN ICES-3(B)/NMB-3(B)
QuICK START GuIDE
Bluetooth connect
UK DE DK FR
11
15
23
31
37
JP
5