PNI S002 Manuel D'utilisation page 4

WARNING: Installing and configuring this equipment requires basic electrical, electronic and security systems knowledge to
correctly interpret all technical information and procedures. Otherwise, we recommend that you turn to qualified personnel.
I. Main features:
• Outdoor siren with backup battery and light signaling
• Double housing: 3 mm external PC case with UV protection, plus 0.8 mm metal inner case
• Continuous frequency modulated sound
• Tamper protection in 3 ways –screw or cover opening or tearing housing from the wall.
• Positive and negative alarm trigger input
• Trigger input to active only the flashlight
• Siren period can set as follow trigger or 3 min cutoff
• Alarm by main power failure
• Protecting against totally battery discharge
• Plug terminal for easy installation
• Environmental immunity
II. Alarm function description:
The alarm can be triggered by applying high or low voltage to the "GO+" or "GO-"inputs terminals respectively. The sound and
flashlight triggere together.
Alarm siren duration depended on the trigger selector state (2):
- F.T. (follow trigger) - the siren sounds until the alarm source is removed or the system is disarmed
- TMR - siren cutoff after 3 minutes, this state is recommended in order to avoid violation of any local regulations
The flashlight can be triggered by applying "low" level to "FL-" terminal. The flash will light up as long as there is an alarm..
III. Tamper:
Tamper: The tamper is normally closed while the housing is closed with the screw, so in this state the tamper terminals
•
are shorted (0 ohm).The tamper will open while opening the screw the tamper socket to the wall properly.
• Power Failure: on power failure the siren and flashlight are triggering, until power supply is restored or time out (5
minutes) expires.
IV. Battery protection:
The siren is supplied with protection against totally battery discharge, when voltage level falls down to less then 8VDC.
V. Installation instructions:
• Choose the mounting location for the siren. The wall must be even and free of hole and excessive protrusions
• Mark and drill 5 holes with help of attach drill pattern plate (4 holes for the housing based and 1 for the tamper)
NOTA: Take into consideration the wires inputs.
• Open the siren housing (1 screw in front) and then remove the metal case from underneath (2 screws).
• Unplug the terminal on the siren driver
• Mount the siren housing on the wall
• Connect the wires to the terminal
IMPORTANT: Cut off the power before you make the connection
• Plug the terminal to your drive board
• Power on the system and check that its function properly
• Connect the back-up battery
IMPORTANT: Keep attention tto he polarity of the battery; a reverse polarity can cause damage of the driver circuit
• Install the metal back case with the two screws
• Close the main case
VI. Terminal block connection:
"FL-" – Flash trigger terminal; connect it to an alarm output of an alarm system
"Go+" – Terminal for tsiren trigger at a positive front; connect it to an alarm output of an alarm system
"Go-" – Terminal for siren trigger at a negative front; connect it to an alarm output of an alarm system
"GND" – gound terminal
"12V" – 12V power supply terminal: connect this terminal to a power supply 13.8 – 14.2 VDC (usually at the alarm system)
"Tamper" – trigger sabotage alarm terminal: connect these terminals to a 24-hour zone of the alarm system
Wired outdoor siren PNI S002
User manual
4