Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.2
door glass replacement
WARNING
!
•
Do not use substitute materials.
•
Glass may be hot. Do not touch glass until cooled.
•
Care must be taken when removing and disposing of any broken door glass or damaged components. Be
sure to vacuum up any broken glass from inside appliance before operation.
•
Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, broken, or scratched.
Replacement glass/frame assembly shall be replaced as a complete unit as supplied by the appliance
manufacturer.
5.3
log placement
WARNING
!
•
Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
with this appliance may result in property damage or personal injury.
•
Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
appliance may not function properly and delayed ignition may occur.
•
The logs are fragile and should be handled with care.
In order to assemble the log set, the glass door must be removed (see "glass door installation and removal" sec-
tion).
1
A.
Place the rear log (W135-0322)(1) as shown,
ensuring the holes on the underside are placed
onto the 2 pins of the log support.
C.
Place the center log (W135-0325)(3) as
shown. Follow contour of burner and ensure
port holes are not covered.
BRACKET
3
2
B.
Place the left log (W135-0323)(2) as shown,
ensuring the hole on the underside is placed
onto the burner pin. This will rest on the left side
of the rear log.
D.
Place the hole in the underside of the right log
(W385-0324)(4) onto the locating pin, on the
burner base and resting against the rear log
(W135-0322)(1) as shown.
E.
Reinstall the glass door.
fi nishing
EN
4
33
W415-2360 / A / 10.31.19
Publicité
Chapitres
Table des Matières
