HSM SECURIO P44 Notice D'utilisation page 15

5 Operation
Switching on the shredder
• Only US-version: Set mains switch at rear of
paper shredder to „I".
• Check that no paper is in the paper feed slit.
• Press the operation button.
 The "Ready for operation" indicator lights up.
Shredding paper
• Paper thickness measurement PAPERcontrol
The document shredder features an inte-
grated paper thickness measurement. This
allows you to check whether a stack of paper
can be shredded in a single go.
• Slide the stack of paper into the control slot.
 After a short time lag, the display on the
operating control lights up:
in green: The stack of paper can be shred-
ded.
in yellow: The amount of paper is within the
machine's upper capacity range.
Reduce the number of sheets in
order not to damage the machine
and prevent a paper jam.
in red: The number of sheets exceeds
the maximum cutting capacity of
the machine. Prevent the cutting
unit from blocking by reducing the
amount of paper.
Remove the stack of paper.
09/2015
• Feed the paper into the centre of the paper
slot.
The light barrier starts the cutting unit auto-
matically. Therefore, with thin paper strips,
make sure the light barrier detects them.
NOTICE
Do not shred paper in the CD cutting unit.
This can cause damage.
Note
Paper and CD cutting unit cannot be used at
the same time. Only shred one kind of mate-
rial at a time.
 3 seconds after the light barrier in the paper
feed opening is free again, the cutting unit is
switched off automatically and the shredder
switches to standby.
SECURIO P 44
english
15