Setup Wizard - PURE Elan Connect/+ Mode D'emploi

Setup wizard

When the Elan Connect/+ is tuned on for the first time, it runs through a setup wizard to configure settings for
date/time and network. Once this has finished, the system is ready to use in most modes.
Note: To change these settings later, select Menu >System settings > and select the required settings
option(s). To run the setup wizard again, select Menu > System settings > Setup wizard.
The Network settings can be reset later by manually running the Network wizard, select Menu > System
settings > Network >Network wizard .
Select Yes to start the setup wizard. If you choose No, a second screen asks if you would like to run
the wizard next time the Elan Connect/+ is started; select Yes or No. The system then starts without
configuring time/date and network settings and enters the Main Menu.
Note: If power is removed while the wizard is in progress, the wizard will run again next time the Elan
Connect/+ is started.
Network
Elan Connect/+ is compatible with all common network protocols and encryption methods, including Wi-Fi
Protected Setup (WPS).
To connect Elan Connect/+ to your network, you need a Wi-Fi wireless router, together with password
key if set.
SSID
Your Wi-Fi
Other Wi-Fi 1
Other Wi-Fi 2
Other Wi-Fi 3
Other Wi-Fi 4
Select 'Network wizard' , and then select a network from the list.
If the network is open (non-encrypted), Elan Connect/+ connects and no further details are
required; see Completion below.
Password protected network
Key:
a
0 1 2 3 4 5 6
7 8 9 .
, a
f g h i
m n o p q r s
To enter the network's key (password), use the Select control to highlight the next relevant
character and press to select each character in turn.
Backspace, OK and Cancel are included to the right of the password screen. These can be
accessed just using the Select control. Pressing the Info key moves the selection highlight to the
Back Space option and back again.
BKSP
- _ @ OK
b c d e
CANCEL
j k l