Auto-Update; Backlight - PURE Elan Connect/+ Mode D'emploi

Auto-update

Auto-update works with data sent over DAB, FM or network. The clock is only updated
when in a corresponding mode, so it is best to select a mode you use regularly.
DAB and FM use time signals broadcast with radio transmissions.
Network uses a time signal sent from the Internet radio portal when in any network-
connected mode.
1. Select Update from DAB, Update from FM, Update from Network or No update.
2. If you are updating from the network, set your time zone.
3. If your country uses daylight saving, the automatically updated time from the network
may be wrong by one hour. When daylight savings are in effect (during the summer),
turn on the Daylight savings option to rectify this.
Note that if you are updating the time from DAB or FM, the Daylight savings option has
no effect on the clock's time.
Elan Connect/+ will auto-update from the selected Mode when time information is
available.
Language
The default language is English. To change, select Menu > System settings > Language >then
select your language.
Factory reset
A factory reset clears all user defined settings, replacing them with the original default values, so
time/date,preferences/ settings and DAB station list are all lost.
If you select Factory reset, you are asked to confirm by selecting "Yes".

Backlight

The Elan Connect/+ has a backlight with three brightness settings, and adjustable timeout (this is
the time delay, in seconds, after which the display switches to the Dim level).
There are three settings:
Timeout - Light On | 10 | 20 | 30 | 45 | 60 | 90 | 120 | 180 sec
On level - High | Mid | Low
Dim level - High | Mid | Low