➌ Trouble Shooting; Symptoms And Confirmation - Elmo MX-1 CONNECT BOX Manuel D'instructions

➌ TROUBLE SHOOTING

■SYMPTOMS AND CONFIRMATION

Check the following items. If any abnormality is found, consult the dealer from whom you
purchased the product or our nearest branch/office.
Symptom
No image is displayed.
日
本
語
The output image
(resolution) changes
automatically.
The image is out of focus.
The image is too dark.
The image does not move.
Possible cause/ remedy
・ The cable is not correctly connected.
・ The AC adapter is disconnected from the wall outlet.
・ The AC adapter is disconnected from the power supply
socket of the unit.
・ Zoom is set at TELE side, displaying only the white or
black part of the document.
・ If you turn the power ON immediately after turning it OFF,
the unit may not start. Wait for several seconds after
turning the power OFF, and then turn it back ON.
・ The output setting does not match the cable connected to
the unit. Set the correct output setting.
・ Reconnect the AC adapter and the power cable.
・ The monitor is not turned on.
・ The input source of the monitor is not set correctly.
・ The switch in the side panel is set to the left. Make sure
that the switch is set to the right.
・ When the HDMI monitor is connected to the MX-1, the
output image (resolution) is automatically changed based
on information from the connected monitor.
・ The document (object) is too close to the lens. Move the
document (object) slightly away from the lens.
・ The intensity of the lighting is insufficient. Set the MX-1 to
the Brightness mode from the Operating panel and adjust
the brightness by pressing
to the Zoom mode and turn on the LED lighting by
pressing button (short press).
・ The "Freeze" function is selected by pressing
on the Operating panel of the MX-1. Cancel the freeze
status by pressing
24
button. Or set the MX-1
button again.
button