Specific Safety Rules And Symbols; Functional Description - Hilti TE 6-S Mode D'emploi

4. Specific safety rules and symbols

4.1 Basic safety information
In addition to the safety precautions listed in the indi-
vidual sections of these operating instructions, the fol-
lowing points must be strictly observed at all times.
4.2 Correct use
The tools are designed for drilling in concrete, masonry,
plasterboard, wood and metal.
The tools are designed for use on construction sites, in
workshops, for renovation, conversion and construction
work.
4.3 Incorrect use (misuse)
Operate the tool only when connected to a mains supply
with a voltage and frequency that complies with the infor-
mation given on the name plate.
Manipulation or modification of the tool is not permissi-
ble.
Observe the information printed in the operating instruc-
tions concerning operation, care and maintenance.
4.4 State of the art
● The tool is designed and manufactured according to
the state of the art.
● The tool and its ancillary equipment may present haz-
ards when used incorrectly by untrained personnel or
not as directed.
4.5 Proper arrangement and organisation of the
workplace
● Wear non-slip shoes and always work from a secure
stance.
● Avoid unfavourable body positions.
● Objects which could cause injury should be removed
from the working area.
4.6 General hazards presented by the tool
● Always hold the tool securely with both hands.
● Hold the side handle tightly at its farthest end.
● Never leave the tool unsupervised.
4.6.1 Electrical hazards
● When working outdoors, use only extension cords
that are approved and correspondingly marked for this
application.
Printed: 07.07.2013 | Doc-Nr: PUB / 5071103 / 000 / 00
Extension Cord Table
Volts Total Length of Cord in Feet
120 V 0–25
240 V 0–50
Ampere Rating AWG
More Than Not More Than
0 6 18
6 10 18
10 12 16
12 16 14
4.7 Requirements to be met by users
● The tool is intended for professional use.
Symbols used on the tool:
V ............................ volts
~ ............................ alternating current
Hz............................ hertz
A ............................ amperes
n ............................ no load speed
0
/min ............................
∅ ............................ diameter
Z ............................ double insulated

5. Functional description

The TE 6-S rotary hammer drills with selectable pneu-
matic hammering mechanism are electrically-powered
tools for drilling in concrete, masonry, plasterboard (dry-
wall), wood, plastics and metal.
The tools are designed for professional use.
Chuck
– with rotary locking action
– Interface for TE-C chuck and keyless chuck
Switches
– Speed-control switch
– Function selection switch
TE6-S: 3 drilling functions
– Reversing switch (switch for forwards/reverse rotation)
Side handle
– Privoting side handle with depth gauge
Lubrication
– The gearing section and hammering mechanism fea-
ture permanent grease lubrication.
The items supplied as standard equipment include:
– Rotary hammer drill
– Privoting side handle with depth gauge
– Grease
– Operating instructions
– Toolbox
– DRS dust-removal module (with version in the pro-
fessional toolbox)
– Cleaning cloth
26– 50 51–100 101–150
51–100 101–200 201–300
16 16 14
16 14 12
16 14 12
12
Not recommended
revolutions per minute
5
en