Using The Hood; Electric Control Panel; Lighting - SCHOLTES HP 90 I Mode D'emploi

Using the hood

1. The hood has several operating speeds.
GB
For more efficient performance, use the lowest
suction level when there is only a small amount of
smoke or steam and the higher suction level when
there are large amounts of smoke and steam;
there is also an intermediate suction level, which
should be used when the amount of smoke and
steam produced by the cooking process is at a
normal level.
2. We recommend that the hood is switched on a
few minutes before the cooking process is
started, and that it is only switched off after all
the odours have been completely eliminated.
Please note: The product can be supplied with a
remote control on request.

Electric control panel:

4 5
1 2 3
O
F C
1
2 3
1. Motor ON/OFF button
2. ON button; also used to select the motor speed 1
- 2 - 3 - 1 - 2
3. Speed 1 indicator LED
4. Speed 2 indicator LED; also indicates when the
grease filter is saturated (in which case the LED
flashes - see instructions relating to cleaning the
grease filter).
5. Speed 3 indicator LED; also indicates when the
active carbon filter is saturated (in which case the
LED flashes - see instructions relating to replacing
the active carbon filter).
Warning! The device signalling the active carbon filter
saturation is deactivated.
If you wish to install an active carbon filter, activate
the device signalling the active carbon filter
saturation by pressing the buttons 2 and 7
simultaneously and holding them down for 3
seconds. At the start of this process, only LED 4 will
be flashing; after 3 seconds LED 5 will also begin to
flash, to indicate that the active carbon filter
saturation detection device is now active.
To deactivate it, press the two buttons again: after 3
seconds LED 5 will stop flashing and the device will
be deactivated.
6. Intensive speed indicator LED
7. Intensive speed activation button.
O
6 7 8
We recommend that this speed is used when there is
a particularly high concentration of smoke and
odours (for example, when cooking fish or frying
food).
Once activated, the intensive speed function
operates for approximately 5 minutes, after which the
previously selected operating speed (between 1 and
3) is restored or the appliance even switches off if no
speed at all was selected previously. To deactivate
the intensive speed function before 5 minutes have
elapsed, press button 1 or button 2.
8. Lights ON/OFF button
The level of illumination can be adjusted using button
8. If the button is pressed once the lights are
switched on at the maximum level. When the button
is pressed a second time, the illumination level is
reduced to medium. When pressed a third time, the
lights switch off.
If any problems relating to the operation of the
I
appliance arise, before contacting the technical
assistance service, unplug the product to disconnect
it from the electricity supply for at least 5 seconds,
then reconnect it. If the problem persists, make sure
that the control panel is connected to the main
control unit inside the hood correctly. If the problem
has still not been resolved, contact the technical
assistance service.

Lighting

Disconnect the appliance from the electricity supply.
a. Remove the cover of the recessed lamp by using
a small screwdriver to lever it out (Fig. 4).
b. Replace the faulty lightbulb with an identical one.
c. Replace the lamp cover.
d. If the lighting system does not work, make sure
the lamps have been inserted correctly before
contacting the technical
assistance service.
Fig. 4
9