Publicité
Les langues disponibles
Les langues disponibles
OBJ_BUCH-0000000240-001.book Page 15 Wednesday, December 9, 2015 11:30 AM
Working instructions.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acciden-
tal starting of the power tool.
Do not use accessories not specifically intended and recommended for this power tool by FEIN.
The use of non-original FEIN accessories can lead to overheating of the power tool and destroy
it.
For each job, use only the FEIN application tool released and intended for the
CAUTION
respective application.
Switching on and off (figure 7).
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
Guide the power tool toward the work
piece only when switched on.
Switching on:
Push the switch toward the front (I).
Switching off:
Push the switch toward the rear ().
Setting the oscillating frequency
(figure 8).
Adjust the oscillating frequency infinitely vari-
able with the dial control.
Turn the dial control between "1" for the
lowest speed and "6" for the highest speed.
Fig. 7
Fig. 8
Thumbwheel for
pre-selection of
oscillating frequency
6
5
4
3
en
15
On/Off switch
2
1
Publicité
