Slave Mode - Cameo OTOS H5 Manuel D'utilisation

DMX OPERATION VIA W-DMX
Starting from the main display, press MENU to enter the main menu. Use UP and DOWN to select
the Control menu and press ENTER. Now select the menu itemW-DMX and confirm again.
See the table below for information on the sub-menu items in the W-DMX menu and the relevant
setting options.
W-DMX
DMX Address
Mode
Receive
DMX XLR Out

SLAVE MODE

Starting from the main display, press MENU to enter the main menu. Use UP and DOWN to
select the Control menu and press ENTER. Now select the menu item Slave and confirm again.
Connect the slave and the master unit (same model, same software version) with a DMX cable
(Master DMX OUT – Slave DMX IN) or via W-DMX (pair both devices), enable the standalone
operating mode on the master unit and start a scene (Run Scene). The slave unit will now follow
the master unit.
Information on the sub-menu items in the Slave menu and the corresponding setting options can
be found in the table below.
18
Setting the DMX start address
Selecting the DMX mode
Deactivate reception via W-DMX
Activate reception via W-DMX
Disconnect all connections and place in pairing standby
mode
Do not output incoming W-DMX signal via DMX OUT (XLR)
Output incoming W-DMX signal via DMX OUT (XLR)
001–486
26CH Standard
32CH Extended
Off
On
Unlink
Off
On