Replacing Gobos - Cameo OTOS H5 Manuel D'utilisation

5. Use the two calibration screws to centre the hotspot (see markings).
5
6. Remove the old seal from the groove in the lamp compartment surround.
7. Thoroughly clean the groove and the contact surface of the fan unit. Make sure that the
contact surfaces of the seal are free from foreign objects and dirt.
8. Remove the new seal from the packaging and remove any residues of the mould release
agent.
9. Now place the seal positively into the groove. Ensure that the seal is not twisted.
10. Place the fan unit flat on the lamp compartment.
11. The screws of the fan unit must now first be tightened crosswise with low force.
12. The screws of the fan unit must then also be tightened crosswise to 6 (± 0.5) kgf-cm.
13. After mounting the fan unit, perform a leak test.
14. After the leak test, fasten the safety cable of the rear head cover in the appropriate position,
place the head cover on the spotlight head and screw it in place using the previously loosened
screws (10 (± 0.5) kgf-cm).
Never operate the spotlight without the fan unit and head cover!

REPLACING GOBOS

ATTENTION:
Gobos may only be replaced by qualified specialist personnel. If you are not qualified
to do this, do not try to replace gobos yourself. Refer instead to professional
companies.
When carrying out any work, make sure that no foreign bodies enter the housing!
When replacing the gobos, make sure that the gobos are inserted correctly into the
corresponding gobo bracket, otherwise heat damage to the gobos and gobo brackets
may occur!
31