Overview Of The 4 Modes; Start Motor; Change Motor Direction Of Rotation; Control With Footpedal - Nouvag TCM 3000 BL Mode D'emploi

NOUVAG AG

5.3 Overview of the 4 modes

There are 4 available modes for motor control. Press the corresponding key on the control unit to
select the desired mode.
Mode 1:1 - variable rotational speed
- For work with handpiece 1:1
- Rotational speed range: 500 - 40'000 Upm
- Reduce rotational speed with key ▼
- Increase rotational speed with key▲
DTM Mode - Fixed rotational speed
- Fixed rotational speed at 8000 Upm
LIPO Mode - Fixed rotational speed
- Fixed rotational speed at 10'000 Upm, corresponds to approx. 3'700 travels with handpiece
THP Mode - Fixed rotational speed
- Fixed rotational speed at 8000 Upm

5.4 Start motor

F F F F
The motor can be started by activating the footpedal step
For safety reasons, the motor only runs if the footpedal is connected

5.5 Change motor direction of rotation

- Press key "ß ß ß ß "
à à à à The green light on key "ß ß ß ß " appears when the motor is set to run-back. Additionally, an acoustic
signal is heard while run-back is operated.

5.6 Control with footpedal

3
2
1

5.7 Optimise the contrast of the display

If necessary the contrast of the display can be optimised with the following keys:
- Press keys "▼" and "MOTOR" together: contrast becomes slighter
- Press keys "▲" and "MOTOR" together: contrast becomes stronger
No. 31739 35/05

Step: - not pressed: motor off
- slightly pressed down: motor runs slowly
- completely pressed down: motor runs
4
‚
Rotational speed:
ƒ
Programme: changes mode
„
Direction of rotation: changes direction of rotation
TCM 3000 BL
(only in mode 1:1)
with set rotational speed
changes maximum rotational
speed (only in mode 1:1)
1:1 ► DTM ► LIPO ► THP ► 1:1 ► ...
5